FingerTec m-Kadex Manual - Manual (Page 12)

12 CONTENTS
Once done, a popup window will appear indicating the update is successful. Click OK
to proceed. The Ingress software has to be synced with all relevant devices in order for
the changes to take effect. A small window will appear at the bottom left corner of the
screen once any changes are made.
Click on the underlined blue sentence to sync the terminals. Any changes made will
appear in the
Synchronize Device Settings window. Check/Tick the changes needed to
be synced to the terminals. Click Start Synchronize once the selections are made. An-
other popup window will appear, displaying the changes made at the particular doors
affected. Click
Start Synchronize once everything is confirmed.
Once synchronization is complete, click Close to proceed. Go to Other tab and click on
Reboot Device . A window will pop up, seeking confirmation on whether to restart the
device. Click Yes and the IP address for the terminal has been successfully changed.