FingerTec Face ID 4d - Manual (Page 27)

2
12 • ACCESS
(Face ID 4dd only)
Most Commonly Used Access Features
The Face ID dd can be connected to door access accessories like electromagnetic
lock and doorbolt to control access to doors. FingerTec provides all kinds of doorlock
accessories which can be viewed at accessory.fingertec.com. Under Access Control
Parameter In Access icon, you can configure most common used functions, which
are explained below. To access to Access Control Parameter: Menu > System > Access
Control Settings > Access Control Parameter
how Long it taKes BeFore the door LoCKs again
(Lock Delay)
This value is the time period for the door to lock again after it unlocks on a successful
verification. The default value is 10 seconds and the range is between 1 to 10. A tap
on the value will prompt a keypad. Input the value in seconds.
deLaying door sensor
(Door Sensor Delay)
This function only works if a door sensor is available. When a door does not close for
a specified time, the sensor will trigger alarm system. Specify the time of the delay.
Default value is 10s, the range is 0-99 s. A tap on the value will prompt a keypad. Input
the value in seconds.
Choosing door sensor type
(Door Sensor Mode)
There are two types of door sensors available for door access which are Normally Open
(NO) and Normally Close (NC). Once a door sensor is available, you have to choose the
door sensor type. Default is None.
deLaying aLarM
(Alarm Delay)
This function only works when there is alarm system installed with Face ID d. You can
adjust the time before Face ID d triggering an alarm system if the door is not closed.
A tap on the value will prompt a keypad. Input the value in seconds. The default value
is 5s.