FingerTec Face ID 4d - Manual (Page 11)

11
1 8
TOP
FRONT
1 8
Joint 1 pin Joint 2 pin
TX+ 1
• •
RX+
TX- 2
• •
RX-
RX+
• •
1 TX+
RX-
• •
2 TX-
note
Link all cables to the correct connection point(s) before attempting to connect the
terminals to the software.
Descriptions of Available Connections
UsB port
Linking with USB flash disk for remote data transfer.
tCp/ip port
Connect with a CAT 5 cable for LAN connection, one end to terminal’s port and
another end to the computer’s TCP/IP Port.
TCP/IP for Single Connection
Linking the terminal to a single computer using TCP/IP
requires Ethernet 10/100Base-T Crossover Cable. The
cable can be used to cascade hubs or to connect Ether-
net stations back-to-back without a hub. It works with
both 10Base-T and 100Base-TX.
TCP/IP for Network Connection
Linking the terminals to multiple computers using TCP/IP requires Ethernet 10/100Base-T Straight Thru
Cable or “whips”. The cable works with both 10Base-T and 100Base-TX, connecting a network interface
card to a hub or network outlet.
power sUppLy port
Insert the Power Adapter point to this port for power.
aCCess ConneCtion
Links the terminal to a door lock system.
ConneCtor pin CaBLe CoLor ConneCtor
TX+ 1
•
White/Orange
•
1 TX+
TX- 2
•
Orange
•
2 TX-
RX+
•
White/Green
•
RX+
•
Blue
•
5
•
White/Blue
•
5
RX-
•
Green
•
RX-
•
White/Brown
•
•
Brown
•