FingerTec Face ID 3 Manual - Manual (Page 27)

2
9 • AUTO TEST
Who should do the Auto Test?
Auto Test page is to diagnose or analyze the conditions in the Face ID . There are
several tests available in the Auto Test page and only an administrator is allowed to
perform the test. Before running any tests, kindly contact your reseller for advice or
you could email [email protected]
Is the Screen OK?
Test Screen determines the quality and sensitivity of the Face ID touch screen
panel. You will see lines of different colors; click the screen to continue testing. If
there’s a broken line or distorted colors on the screen, kindly send your Face ID
for repair. Menu > Auto Test > Test Screen
Checking the Voice Message
Test Voice determines the quality of the Face ID ’s audio. Every click on the screen
will emit different voice message. If you find any distorted sound in any of the voice
message or instruction, kindly send your Face ID for checking. Menu > Auto Test
> Test Voice
Checking the Infrared Camera
To know the condition of the infrared face scanner, you need to run face test. The
Face ID will display 2 images of your face: color display and infrared. Make sure
both cameras capture and show your face image. Look at the infrared camera cap-
ture image, make sure it is a square in the middle of the screen; you have to look
into the camera. If you can see your image in the square, the camera is working fine.
Check the quality status bar to adjust to the best capture image. Otherwise, kindly
send your Face ID for checking. Menu > Auto Test > Test Face
Is the Time Accurate?
Time is an essence in the Face ID and it can’t be compromised. The Test Time will
display date, time, 0 (s): 0 (ms). Tap the screen to start the test. The 0 (s): 0 (ms) will
start to run and every 10ms change the second to 1. If it doesn’t run well, kindly
send your Face ID for checking. Menu > Auto Test > Test Time