FIAT 2013 500 User Manual

Page 82

concerning the “Trip A” makes it possible to reset only
the information associated with this function.

• The reset operation in the presence of the screens

concerning the “Trip B” makes it possible to reset only
the information associated with this function.

Start Of Trip Procedure
With ignition key on, press and hold the TRIP button for
over one seconds to reset.

Exit Trip
The TRIP function is over when all the values have been
displayed or holding the MENU ESC button for longer
than one second.

Personal Settings (Customer-Programmable
Features)

Dimmer
The EVIC display is provided with a light sensor capable
of detecting environmental light conditions and adjust-
ing the brightness of the instruments accordingly.

NOTE:

The brightness of the instrument panel may

change while travelling following an event causing
switching from “day” to “night” conditions (or vice
versa) in the passenger compartment (e.g. in a tunnel, on
avenues in shadows, under bridges, etc.).

To adjust the brightness, proceed as follows:

• Press the + or – button to set the required brightness

level;

• Briefly press the MENU ESC button to go back to the

menu screen or press and hold the MENU ESC
(approximately one seconds) to go back to the main
screen without storing settings.

Speed Beep (Speed Limit)
With this function it is possible to set the car speed limit
(mph or km/h); when this limit is exceeded the driver is
immediately alerted.

To set the speed limit, proceed as follows:

• Briefly press the MENU ESC button, the display will

show the message (Speed Beep);

• Press the + or – button to select speed limit activation

(On) or deactivation (Off);

• When the function is activated (On) pressing the + or

–

buttons select the speed limit and press MENU ESC

to confirm selection.

NOTE:

Selection is possible between 20 and 125 mph

(30 and 200 km/h), or depending on the selected unit.
The setting will increase/decrease by five units each time
the +/– button is pressed. Press and hold the +/– button to
increase/decrease the setting rapidly. Complete the set-
ting by briefly pressing the button when you approach
the required setting.

• Briefly press the MENU ESC button to go back to the

menu screen or press and hold the MENU ESC button
(approximately one seconds) to go back to the main
screen without storing settings.

To cancel the setting, proceed as follows:

• Briefly press the MENU ESC button (On) will flash on

the display;

• Press the – button (Off) will flash on the display;