FIAT 2013 500 - Manual (Page 109)

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
Never leave children in the vehicle alone. Leaving
unattended children in a vehicle is dangerous for a
number of reasons. The child or others could be
seriously or fatally injured. The child could operate
power windows, other controls or move the vehicle.
Manual Transmission – If Equipped
Apply the parking brake, place the shift lever in NEU-
TRAL, and press the clutch pedal before starting the
vehicle. This vehicle is equipped with a clutch interlock-
ing ignition system. It will not start unless the clutch
pedal is pressed to the floor.
Automatic Transmission – If Equipped
The shift lever must be in the PARK or NEUTRAL
position before you can start the engine. Apply the brakes
before shifting to any driving gear.
NOTE: You must press the brake pedal before shifting
out of PARK.
Normal Starting
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal.
Turn the ignition switch to the AVV (START) position and
release when the engine starts. If the engine fails to start
within 10 seconds, turn the ignition switch to the STOP
(OFF/LOCK) position, wait 10 to 15 seconds, then repeat
the “Normal Starting” procedure.
1
Cold Weather
To prevent possible engine damage while starting at low
temperatures, this vehicle uses a viscosity sensor to
determine the thickness of the oil before the engine is
allowed to start. During the viscosity measurement (up
to 10 seconds) the glow plug light will be continuously
illuminated in the instrument cluster and the starter will
be disabled. If the viscosity is OK, the glow plug symbol
will go off and the engine will be allowed to crank. If the
measured oil viscosity is too high (thick), engine cranking
will be disabled and the glow plug light will blink
repeatedly until the oil temperature is raised, preferably
by an externally-powered electric engine block heater
(available from your authorized dealer).
The message Љplug in engine heaterЉ will be displayed in
the instrument cluster when the ambient temperature is
below –4°F (–20°C) at the time the engine is shut off as a
reminder to avoid possible crank delays at the next cold
start.
CAUTION!
Use of the recommended SAE 5W-30 oil and adher-
ing to the prescribed oil change intervals is important
to prevent engine damage and ensure satisfactory
starting in cold conditions.
If Engine Fails To Start
WARNING!
• Never pour fuel or other flammable liquids into
the throttle body air inlet opening in an attempt to
start the vehicle. This could result in a flash fire
causing serious personal injury.
(Continued)
2