FIAT 2013 500 - Manual (Page 136)

TIRE CHAINS
Use only compact chains, or other traction aids that meet
SAE type “Class S” specifications. Chains must be the
proper size for the vehicle, as recommended by the chain
manufacturer.
NOTE: Do not use tire chains on a compact spare tire.
CAUTION!
To avoid damage to your vehicle or tires, observe the
following precautions:
• Use Security Chain Co. (SCC) SCC Z6 low profile
or equivalent chains on 185/55R15 tires only.
(Continued)
CAUTION! (Continued)
• Because of restricted chain clearance between tires
and other suspension components, it is important
that only chains in good condition are used. Bro-
ken chains can cause serious damage. Stop the
vehicle immediately if noise occurs that could
indicate chain breakage. Remove the damaged
parts of the chain before further use.
• Do not exceed 45 mph (70 km/h).
• Drive cautiously and avoid severe turns and large
bumps, especially with a loaded vehicle.
• Install chains on the front wheels as tightly as
possible and then retighten after driving about
0.5 mile (0.8 km).
• Do not drive for prolonged periods of time on dry
pavement.
(Continued)
1
CAUTION! (Continued)
• Observe the tire chain manufacturer’s instructions
on the method of installation, operating speed,
and conditions for use. Always use the lower
suggested operating speed of the chain manufac-
turer, if different from the speed recommended by
the vehicle manufacturer.
Always use the lower suggested operating speed if the
chain manufacturer and vehicle manufacturer suggest
different maximum speeds. This notice applies to all
chain traction devices, including link and cable (radial)
chains.
2