D.A.S. Audio Aero 48 - Manual (Page 5)

STACK FLY
For flying boxes and defining the splay
angle, the pins must be inserted in the slot of guide 2,
G2A48, whereas for stacking (
), the pin goes
through the top hole of the guide.
stacked
All of the elements needed to rig or stack the
systems are integral to the enclosure (
and the quick release safety pins). The additional
items needed are the AX-AERO48 flying grid (bumper
bar), chains and hoists, the PL-48 or PL-48S dolly
platforms and the AX-COMBO flying grid. G1A48, G2A48
A) AX-AERO48
The AX-AERO48 grid is made from 100 x 50
x 6mm steel tubing and is designed to handle great
loads. It features a center reinforcement bar that is
also used for the lifting slings. The force of both the
rear and the front chain hoist will determine the tilt
angle of the whole array. The structure will be
attached to the first enclosure of the array by means of
the guides G1A48, G2A48, and six quick release
safety pins.
Weight
Dimensions: 144x93x10 cm
(H x W x D)
: 75Kg (165 lbs)
57x36.6x4 in
Pickup points
B) Chain hoists
All units in a column will be flown from the
AX-AERO48 flying grid (bumper bar), which should be
used with two hoists, one located in the front and the
other in the rear. The hoists should have a minimum of
1 Ton load capacity when flying up 8 units and a 2 Ton
load capacity when flying 9 to 16 units.
Chain hoist load capacity
>1000Kg
>2000Kg
1 8cabinets -->
9 16cabinets -->
C) Platform PL-48
The PL-48 dolly panels facilitate transport of
the AERO-48 systems. They can also be used to
facilitate flying the systems. Each cover is attached to
the enclosure by using the flying hardware attached
to each box and is fixed with the quick release safety
pins.
PL-48
D) PL-48S
The PL-48S platform is a valuable accessory
which allows up to 3 or 4 AERO-48 units to be
transported in a stacked position, ready to be flown.
The PL-48S is made from steel and has 4 heavy duty
casters with locking brakes.
PL-48S
Aero-48
Manual del usuario/ User´s manual 32