D.A.S. Audio Aero 48 - Manual (Page 13)

Once the two PL-48S_2 have been attached
to the boxes (3) using one safety pin per piece, the PL-
48S_1 pieces can be attached. Remove the safety
pins (4)and insert them into the rigging hardware (5)
securing them (6) by using two pins per piece.
Once the PL-48S_1 and PL-48S_2 have
been secured to the lower box, this should be lowered
so that the PL-48S_1 piece can be secured to the PL-
48S platform (7) using the safety pins.
The lowest box is now attached to the
platform. Now the array should be lowered until the
boxes are resting on one another. When the lower
three boxes are in this position, the safety pins
attached to the G2A48 guides joining boxes 3 and 4
should be removed to separate the array into two
groups of boxes.
On flown systems, boxes are numbered
from top to bottom, the top box being number 1 and
the lower box being number six.
3
6
4
5
7
With the number 4, 5 & 6 boxes resting on
each other, the safety pins that define the splay angle
can be removed (8) and the PL-48S_2 guides can
return to their stored position (9). It is mandatory to
remove the safety pins between boxes 3-4, but
between 4-5, and 5-6, they can be left in place with
the angle prepared for the next event.
4
1
8
8
8
9
9
9
2
3
5
6
40
Aero-48
Manual del usuario/ User´s manual