Comtrol UP DeviceMaster Quick Start - Manual (Page 9)

DeviceMaster UP EtherNet/IP Quick Start: 2000478 Rev. D Configuring Read-Only Serial Devices - 9
Configuring Read-Only Serial Devices
Prerequisites
Before you can configure the serial ports for read-only serial devices, make sure that you have done the
following:
• Installed the hardware
• Installed PortVision DX
• Configured the DeviceMaster UP IP address using PortVision DX
• Uploaded the EtherNet/IP firmware (V3.x or higher) using PortVision DX
If you need to perform any of these procedures or locate the latest files, see Installation Overview on Page 5.
Embedded Web Page Configuration
Use the following procedure to configure read-only serial ports.
1. Access the Server Configuration web page by entering the DeviceMaster UP IP address in your web
browser or by highlighting the DeviceMaster UP in PortVision DX and clicking Webpage.
Note: If the browser does not display the web page correctly, clear the browser history and refresh the
DeviceMaster UP web page.
2. Click the Serial Device Configuration link.