Configuring read-only ethernet tcp/ip devices, Prerequisites – Comtrol UP DeviceMaster Quick Start User Manual
Page 13
DeviceMaster UP EtherNet/IP Quick Start: 2000478 Rev. D
Configuring Read-Only Ethernet TCP/IP Devices - 13
Configuring Read-Only Ethernet TCP/IP Devices
Prerequisites
Before you can configure the serial ports for read-only Ethernet TCP/IP devices, make sure that you have
done the following:
•
Installed the hardware
•
Installed PortVision DX
•
Configured the DeviceMaster UP IP address using PortVision DX
•
Uploaded the EtherNet/IP firmware (V3.x or higher) using PortVision DX
If you need to perform any of these procedures or locate the latest files, see
Embedded Web Page Configuration
Use the following procedure to configure read-only socket devices.
Note: Verify that the Software is Ethernet/IP 3.06 or greater. If it is not, update to the latest version. If
necessary, refer to the DeviceMaster UP Hardware Installation and Configuration Guide.
1.
Access the Server Configuration web page by entering the DeviceMaster UP IP address in your web
browser or by highlighting the DeviceMaster UP in PortVision DX and clicking Webpage.
Note: If the browser does not display the web page correctly, clear the browser history and refresh the
DeviceMaster UP web page.
2.
Click Ethernet Device Configuration to open the Ethernet Device Configuration page.