6, coanect antenna or cable-tv system, Converge colors if necessary, Autoprogram the tv’s – RCA COLOR TV NCJ11 User Manual

Page 6: Channel memory. + bunon, Attach power cord, Thm on tv, adjust the volume, and select a channel

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ipt

Coanect antenna or cable-TV system.

Most antenna or cable-TV systems can be connected as

show here.

Incoming Cable from Antenna or
Cable-TV Syatem

' Details for connecting a home antenna to your TV are on

page 32.

Details for connecting a cable-TV system to your TV

are on pages 33-34.

' Details for connecting a VCR to your TV are on

pages 37-38.

8. Converge Colors if Necessary.

If you notice colored rings or halos around objects in the

picture, you may need to converge the colors. Over a period

of time, the picture tubes can drift out of alignment due to

normal bumps and vibrations or moving the TV. Details for

converging the colors are on page 15.

AutoProgram the

TV’s

channel memory.

+ Bunon

To start the TV autoprogramming

itself, press the

MENU

button

repeatedly to select

SETUP MENU

and then press + to display the setup functions. Repeatedly

press

MENU

again to select

AUTOPROGRAM

function,

and then press -i-. Details are on page 24.

6. Attach power cord.

First attach the flat end of the power cord completely into the

connector on the back of your TV, and then plug the other

end into a wall outlet.

7. Thm on TV, adjust the volume, and select a channel.

* Press the TV button on the

Number
Buttons

0§§E>

o Ф Ф (5

de> »

S=B S>

ÔOÔ "o
25 O

Button

CHANNEL

Buttons

VOLUME

Buttons

remote to turn on the TV.

When using the remote,

remember to point it at the

front of the TV.

• Press the

VOLUME

up or

down button to adjust the

volume to a desired level.

• Press the

CHANNEL

up or

down button to select the next channel in memory. You can

also press two number buttons to select a channel. To select

a 3-digit cable channel (up to channel 128), press and hold

number button 1 until 1- appears on the screen. Then press

the other two numbers. Channels 2-13 were programmed

into the channel memory for you at the factory, so pressing

CHANNEL

up or down stops at these channels only. When

you start the AutoProgramming feature (described in step 9),

your set will automatically scan through all channels and

place only the active channels for your area into its channel

memory.

• Details about using the remote are on page 9-13.

^VidwiMenti

.■Audio Menu

Setup Menu

Xlarm

jChan Label
IParental Ctrl: Off

Chan Ctii: Normal

Autoprogram

You can also add and erase channels from memory as desired.

Press

MENU

repeatedly to select the

SETUP MENU,

then

press + to display the setup functions.

Press

MENU

repeatedly to select (highlight) the

CHAN MEM

function. Select the desired channel number by pressing the

CHANNEL

up or down button or by pressing the two

corresponding number buttons.

mlAbel

Parertal CM: O f f .

,’OhanCtrl: Normal

•JAutoprogram

Chan Mem: Stored

Irarental Ctrl: Off

‘ChanCtrt: Normal

."Autoprogram___

Chan Mem: Erased

Then press + to add a channel, or press - to erase a channel.

Details are on page 24.