RCA COLOR TV NCJ11 - Manual (Page 4)

The steps below will help you get your TV connected and
working quickly. The page numbers on which you can find
detailed instructions for each of these steps are also listed
for your convenience.
1. Unpack TV and accessories.
Shown here are the accessories that came packed with your TV.
Four AAA Batteries for
Remote Four Wing Nuts
Note: A flat, wooden shelf is included with
certain models. Placing this shelf on top of
the TV (right behind the front narrow ledge)
creates a level surface upon which you can
position a VCR or other component if desired.
Power Cord
2. Install batteries in remote control.
Details are on page 8.
3. Extend back cover.
Your projection TV has been specially designed with a collapsible
back cover. This design makes it easier for you to move the TV
through doorways because the collapsed back makes the TV
narrower. After the TV is positioned in your home, you can
easily extend the back cover to its normal operating position by
following the instructions below.
1. Remove the four wing nuts from the literature bag.
2. Remove the two screws (labeled A) from the shipping
brackets. You will use these screws later in step 6.
3. Grasp the shipping brackets and gently pull the back cover
up and out until the locating pins enter the alignment holes.
Keep the back cover tight against the cabinet by holding the
shipping bracket on the right side. Then attach wing nut to
built-in hole screw in hole #1. Hand tighten.
4. Hold left shipping bracket and attach wing nut to built-in
screw in hole #2. Hand tighten.
5. Attach remaining wing nuts to screws in holes #3 and #4 to
ensure stability and best picture quality.
6. Remove the shipping brackets from the back cover and
attach them to the wooden rail with the two screws (A) from
step 2. Reinsert the other two screws from the shipping
brackets into the back of the TV as shown, so they will be
available in case you need to move your TV and want to
collapse the back again.
Back Collapsed
AJignment,
Hole for
Locating Pin
. Alignment
Hole for
Locating Pin
Back Extended
Reinsert
other two
screws here
Wooden Rail