Care amd maintenance, Handling compact discs – RCA RP-9753 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I
CARE AMD MAINTENANCE
Cleaning the System’s Exterior
Before cleaning the system, disconnect AC power to prevent the hazard of
fire or shock.
Ciean the exterior of the unit using a soft dust cloth. If desired, use a soft,
damp cloth and mild soap to clean the display sections — but be careful
not to scratch these sensitive panels!
nCOMPACT
ÉÌE
DIGITAL AUOn
Handling Compact Discs
CARE OF DISCS
•
With this CD player, use discs
which display the mark shown.
• When holding discs, do not touch their signal surfaces. Hold the edges or
one edge and the center of the hole.
• Do not affix labels or adhesive tape to the label surfaces. Also do not
scratch or damage the label.
• Discs rotate at high speed inside the player. Do not use damaged (cracked
or warped) discs.
CLEANING DISCS
•
The presence of finger prints or smudges on the surface of the disc will
not directly affect the recorded signals, but depending on the degree of
contamination, the brightness of the light reflected from the signal surfaces
may be reduced, causing degradation of sound quality. Always keep your
disc clean by wiping them gently with a soft cloth from the inner edge
toward the outer perimeter.
• If a disc becomes very dirty, wet a soft cloth in water. After wringing out
well, wipe the dirt away gently, and then remove any water drops with
another dry cloth.
• Do not use record cleaning sprays or anti-static agents on discs. Also,
never clean discs with benzene, thinner, or other volatile solvents which
may cause damage to the disc surface.
STORING DISCS
• Discs are made of the same kinds of plastic used for conventional records.
Be careful not to allow discs to warp; always store them in their cases, ver
tically, avoiding locations with high heat or humidity, or extremely low
temperatures.