Replenishing the store name stamp with ink – Toshiba TEC MA-79 User Manual
Page 67
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
El-01397
REPLENISHING THE STORE NAME STAMP WITH INK
When the store name is printed too lightly, replenish ink in the following manner.
Fig. 7
1) Turn off the power of the register (or turn
the Mode Lock to the “OFF” position).
2) Remove the Receipt Cover.
3)
Remove the Stamp from the Stamp Print
Unit by pulling out toward the rear of the
register with your fingers on the notches
of both sides as shown in the figure.
(Fig- 7)
4)
Apply ink to the pad on the rear side of
the Stamp. The amount of the refilling
should
be
adjusted
according
to
the
density of the printed message, but the
limit of 2 cc should not be exceeded.
(The ink bottle supplied contains 5 cc of
ink.) (Fig. 8)
Ink Bottle
NOTES: 1) Replenish the ink drop by drop
several times until the pad will
not absorb any more.
2) Use TEC genuine ink for
replenishment.
5. Reassembly is the reverse procedure.
Fig. 8
-
64
-