Toshiba TEC MA-79 - Manual (Page 49)

El-01397
PLU TABLE SETTING OR CHANGING (Submode No.4)
This submode allows programming or changing PLUs (Price-Look-Ups) linked to a
department. When a PLU is entered as a sale item in the “REG” mode, the sale item count
is processed into that particular PLU item memory as well as into its linked department
memory. Thus you can read in the “X” or “Z” reports the sales data of the individual item
as well as the sales total data of the department to which the individual item is linked.
After PLU Reset to change PLU table data once programmed, or any time
outside a sale to program new PLUs.
Mode Lock : SET
4 [@/FORl
t
Submode
No.
1 PLU Code 1 rPLUl ^ ^ 1 Preset Unit Price | fDEPTl
1 to 99; 0 to 999999
No. assigned to (6 digits), resulting in
each PLU item $0.00 to $9999.99
Link<3d
* Dept.
-► [AT/TL]
Repeat for another PLU.
(*: Repeatable from here if the PLU Code is sequential from that of the previous
PLU. if the sequence “| PLU Code | [PLU]” is omitted after the submode
No. entry (i.e. 4 [@/FOR]}, PLU Code No.1 is automatically be assigned.)
NOTES: 1) A maximum of 99 PLUS may be programmed.
2) A zero price may be preset if “0” is entered as “Preset Unit Price”. The
Preset Price entry is compulsory on this register; no open-price PLUs may
be programmed.
3) When the linked department is a Single-item Department, the PLU will also
function as a Single-item PLU. The Tax Status of the PLU is determined by
its linked Department status. When the linked department is a negative
department, no errors result in this programming operation but no entries
through that PLU are possible in the “REG” mode.
ex.) To set the following new PLUs:
PLU Table
PLU
Code
11
12
21
22
Preset
Price
Linked
Depl
$1.00 Depti
$0.50 DepLi
$2.30 DepL2
$3.10 DepL2
Key Operation
Mode Lock to “SET”,
enter 4, depress [@/FOR].
11 [PLU]
(12 [PLU])
21 [PLU]
(22 [PLU)
[AT/TL]
100 [DEPTI]
50 (DEPT 1]
230 [DEPT 2]
310 [DEPT 2]
-
46
-