Toshiba TEC MA-79 - Manual (Page 40)

El-01397
9. READ (X) AND RESET (Z) REPORTS
The following table shows available reports and the key operations to issue those respective
reports. The contents of the X and Z reports are the same if both are available, except that:
1. Symbol X for X (Read) reports, and Z for Z (Reset) reports are printed as the header.
2. A reset count is printed near the end of a Z report (but not on X reports).
3. All the resettable counters and totals will be reset on a Z report issuance, while they will
not be reset on an X report issuance. Therefore, X reports may be taken at any time and
any number of times during the day or at the end of the day. But the Z report is
expected to be taken only once a day usually at the end of tiie day.
TABLE OF X AND Z REPORTS
i
ШШ
Cash-in-drawer Read (Read only) X [#/NS] (Drawer opens.)
PLU Read /моте
PLU Reset
X
z
J [PLU] (Drawer does not open.)
Daily Read /моте o\
Daily Reset
X
z
] [ATyTL] (Drawer opens.)
GT Read /моте q \
GT Reset (MOTE3)
X
z
] 20 [AT/TL] (Drawer opens.)
NOTES: 1) PLUS with zero sales data will be skipped in reports.
2) Print Contents: Departments
Financial
Hourly Ranges
3) Print Contents: Departments
i
Financial
Refer to the report print samples on the following pages.
page
Cash-in-drawer Read Report ................................................................................... 38
PLU Read or Reset Report ....................................................................................... 38
Daily Read or Reset Report ...................................................................................... 39
GT Read or Reset Report .......................................................................................... 41
(The program verification printings, which are available in the “X” position of the Mode
Lock, are placed in the chapter of VERIFICATION OF PROGRAMMED DATA.)
- 3 7 -