Toshiba TEC MA-79 - Manual (Page 51)

El-01397
HOURLY RANGE SETTING OR CHANGING (Submode No. 7)
(for report purposes)
A maximum of 24 hourly ranges may be set in order to read sales data in each hourly range
as part of the Daily X or 2 reports.
After Daily Reset
7 I@/FOR]
t
Submode
No.
LU
Hour
1 to 24
t#/NS]
Enter the time to end
each hourly range, in
the 24-hour system.
Repeat for all hourly
ranges required.
[AT/TL]
NOTES:
1) If an hour value “0” or more than 24 is
entered, no error results. But the sales
data will not be processed correctly in
this case.
2) Do not set an hourly range across 24:00,
such as “from 23:00 to 1:00”.
3) To change the table of hourly ranges
once set, partially or entirely, do the
entire setting operation over again. The
old table will then be cleared.
4) To reset the hourly range table:
Mode Lock : SET,
7 [@/FOR] 0 [#/NS] [AT7TL]
Then no hourly range sates data will be
outputted on the reports.
ex.) To set the following table of hourly ranges:
Table Kev Operation
Mode Lock to “SET”.
« - 0 7 .
7 [@/FOR]
0 8 - 0 0
^ up to 8:00 8 [#/NS]
1 2
-ao
8:00 to 12:00 12 [#/NS]
1 3 - 0 0
12:00 to 13:00 13 [#/NS]
1 5 - 0 0
13:00 to 15:00 15 [#/NS]
1 8 - 0 0
15:00 to 18:00 -i 18 [#/NS]
0 0 1 6 . 1 3 . : 5 4
_______ _______1
[AT/TL]
-
48
-