Denon AVR-3600 - Manual (Page 5)

2 BEFORE USING
Pay attention to the foMowing before using this unit:
9 Moving the set
To prevent short circuits or damaged wires in the connection cords,
always unplug the power cord and disconnect the connection
cords between a!i other audio components when moving the set.
« Before turning the power switch on
Check once again that all connections are proper and that there
are not problems with the connection cords. Always set the
power switch to the standby position before connecting and
disconnecting connection cords.
Store this instructions in a safe place.
After reading, store this instructions along with the warranty in a
safe place. Also fill in the items on the back page for your conve­
nience.
Note that the illustrations in this instructions may differ from
the actual set for explanation purposes.
3 CAUTIONS ON INSTALLATION
Noise or disturbance of the picture may be generated if this unit or any
other electronic equipment using microprocessors is used near a tuner
or TV,
If this happens, take the following steps:
® install this unit as far as possible from the tuner or TV.
® Set the antenna wires from the tuner or TV away from this unit's
power cord and input/output connection cords.
® Noise or disturbance tends to occur particularly when using indoor
antennas or 300 Q/ohms feeder wires. We recommend using
outdoor antennas and 75 C2/ohms coaxial cables.
For heat dispersal, leave at least 10 cm of space between the top,
back and sides of this unit and the wall or other components.
I
ÿ Wall
I
0 CAUTIONS ON HANDLING
® Switching the input function when input jacks are not con­
nected
A clicking noise may be produced if the input function is switched
when nothing is connected to the input jacks. If this happens, either
turn down the MASTER VOLUME control or connect components
to the input jacks.
® Whenever the power switch is tn the OFF state, the apparatus
is stilt connected on AC tine voltage.
Please be sure to unplug the cord when you leave home for, say,
a vacation.
Muting of PRE OUT jacks
The PRE OUT jacks include a muting circuit. Because of this, the
output signals are greatly reduced for several seconds after the
power switch is turned on or input function, surround mode or any
other set-up is changed. If the volume is turned up during this time,
the output will be very high after the muting circuit stops function­
ing, Always wait until the muting circuit turns off before adjusting
the volume.