Denon AVR-3600 - Manual (Page 34)

10-6 Recalling preset stations with the on screen display
1. Press the ENTER button and call out the "Menu" screen from the
on screen display.
2. Use the CURSOR buttons to specify "Tuner Preset Stations",
{screen 29)
CURSOR( CURSOR
3. Press the ENTER button.
The screen switches to the "Tuner Preset Stations" screen, {screen
30)
4. Use the CURSOR buttons to select the station you want to tune in.
V rv
If the selected station is not displayed on the on screen display, use
the CURSOR buttons to switch the displayed page.
CURSOR
5. Once the desired station is selected, press the CURSOR button to
actually tune it in.
6. Once the desired station is tuned in, press the ENTER button. The
"Menu" screen is displayed.
ENTER
7. Use the CURSOR buttons to specify "Menu Off".
8. Press the ENTER button.
ill LAST FUNCTION IVlEiMORY
Menu
System Setup
A Surround Parameters
Tuner Preset Stations
T
Menu Off
( screen 29 )
Tuner Preset Stations
A1 fm 87.50MH z
A2 fm 88.1 OM hz
A A3 fm 89.30M hz
? A5 fm 97.90M hz
A6 fm 104.10M hz
A7 fm 106.50MHz
A8 fm 107.90M hz
{screen 30
® This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power
is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
® The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit's power
switch is off and with the power cord disconnected.
12 INITIALIZATION OF THE IVIICROPROCESSOR
When the indication of the display is not normal or when the operation
of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1. Switch off the unit using the main unit's power switch.
2. Hold the following AC-3 RF button and PHONO button, and turn the
main unit's power switch on.
3. Check that the entire display is flashing with an interval of about 1
second, and release your fingers from the 2 buttons and the micro­
processor will be initialized.
34