Denon AVR-3600 - Manual (Page 22)

7“5 Clearing "learned" remote control signals and the preset memory settings
1. Press the USE/LEARN selector button with
the tip of a pen, etc,, to set the learn mode.
2, To clear "learned" remote control signals,
set the slide switch to the position at which
the signals were "learned". To clear the pre­
set memory settings, set the slide switch to
"VIDEO".
AUDIO
AVR/AVC VIDEO
3. Set the slide switch to the position at which
the signals were "learned" or at which the
preset memory settings were set.
CD DECK DAT
VDPVCR TV
8 OPERATIONS
8“1 Preparations for playback
1. Check that all connections are proper.
2, Set to the center position.
3, Set the remote control unit’s slide switch to the AUDIO position,
(only when operating with the remote control unit)
AUDIO
AVfVAVC VIDEO
Turn on the power.
Press the POWER switch (button).
ON/STAN08Y
----
■ lights
^ON/STANDBY
The power turns on and "ON/STANDBY" indicator is lit,
Several seconds are required from the time the power switch is
set to the "ON" position until sound is output. This is due to the
built-in muting circuit that prevents noise when the power
switch is turned on and off.
Set the POWER switch to this position to turn the power on and
off from the included remote control unit (RC-820).
® ja. OFF
The power turns off and "ON/STANDBY" indicator is off.
in this position, the power cannot be turned on and off from the re­
mote control unit.
22