Denon AVR-3600 - Manual (Page 12)

6-2 Setting the speaker configuration
1. Use the CURSOR buttons to specify "Speaker Configuration" from the "System Setup
Menu" screen (screen 2).
CU^R ^
2. Press the ENTER button.
The "Speaker Configuration Menu" screen (screen 3} appears on the monitor,
3. Use the CURSOR buttons and select the different types of speakers connected and
their size parameters.
To select the speakers:
Л
CURSOR Cv
To select the parameters:
CURSOR CURSOR
The selected parameters are highlighted.
Speaker Configuration
___ gFront Sp.
Center Sp.
Q
О
Surround Sp.
И
Subwoofer
(screen 3 )
® Parameters
Large ............................. Select this when using speakers that can fully reproduce low sounds of below 80 Hz,
Small ............................. Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume.
When this setting is selected, low frequencies of below 80 Hz are assigned to the subwoofer.
None .............................. Select this when no speakers are installed,
Yes/No............................ Select "Yes" when surround speakers and a subwoofer are installed, "No" when they are not installed,
4. After the above selections are completed, press the ENTER button again.
The "System Setup Menu" screen reappears.
6-3 Setting the delay time
Input the listening position and the distance of the different speakers.
1. Use the CURSOR buttons to specify "Delay Time" from the "System Setup Menu"
screen (screen 4).
2. Press the ENTER button.
Д
CURSOR
ENTER
The "Delay Time" screen (screen 5) appears on the monitor.
3. Use the CURSOR buttons to specify the unit of distance,
CURSOR CURSOR
NOTE: The settings are reset to their initial values when switching between meters and
feet.
System Setup Menu
^Speaker Configuration
E3“De!ay Time
^Channel Level
Digital Inputs
AC-3
Auto Tuner Presets
On Screen Display
Setup Menu Off
{screen 4)
Delay Time
Set The Distance To
Each Speakers
Do You Prefer
In Meters ? / in Feet?
□“Meters < • > Feet
(screen 5 )
12