Daily reports, Read (x) and reset (z) reports – Toshiba TEC MA-1400-100 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11014
3. READ (X) AND RESET (Z) REPORTS
The following table shows the key operation to take each report. The “X” and “Z” reports have
exactly the same print content if both are available, except that:
1.
The “X” reports allow to read the sales data but not clear memories, while the “Z” reports
allow to read the sales data and at the same time all the resettable memories will be cleared
when the reports have been issued.
2.
The symbol “Xnn” is printed on the top line of an “X” report, while “Znn" is printed on a “Z"
report, (“nn” is the Report No.)
3. A reset count is printed on the bottom of a “Z” report only.
TABLE OF OPERATIONS FOR X AND Z REPORTS
Daily Reports
REPORT NAME
iii!
.............
SAMPLS
PAGE
i
* FINANCIAL READ AND RESET
• Financial Read
• Financial Reset
] [AT/TL]
PLU READ AND RESET
• All PLU Read
• All PLU Reset
• Zone PLU Read
• Zone PLU Reset
X
Z
X
z
3
[PLU]
Zone-start
PLU Code
I@ff=OR]
Zone-end
PLU Code
[PLUJ
HOURLY RANGE READ AND RESET
• Hourly Read
• Hourly Reset
3 10 [AT/TL]
10
DEPARTMENT READ AND RESET
• All Department Read
• All Department Reset
3
11 [ATH-L]
11
DEPARTMENT GROSS PROFIT
READ
12 [AT/TL]
12
* CLERK READ AND RESET
• Individual Clerk Read
• Individual Clerk Reset
1
Set the required _____
^
.
at
/
ti
i
J clerk key to ON.
'
l A l / I L J
13
* MEDIA-IN-DRAWER READ
[#] (or [#/NS])
14
. 4 .