Power failure process, Journal and receipt paper-end detector – Toshiba TEC MA-1400-100 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11014
9. POWER FAILURE PROCESS
if a power failure occurs, the sales memory is protected by the back-up battery; registration and
printing will normally be performed on regaining the power. However, please note the following cases:
(1)
The printer will work to print the entered data without failure after the power recovery if any data
was being printed. However, one extra line may be fed on the power recovery depending on the
power failure timing.
(2) The following are displayed indications on the power recovery :
ECR CONDITION at the time of Power Failure
DISPLAY INDICATION on
the Power Recovery
OUTSIDE A
SALE.
No Key-in has been operated.
Displays zero Operations
may go on.
Numeric or Declaration Keys (such as [RTN
MDSE], [PR OPEN], etc) have been entered
but not motorized keys.
DURING A
SALE.
No Numeric or Declaration keys have been
entered.
Regain the display
content that was obtained
just before the power
failure.
The operations may be
continue.
Numeric or Declaration keys have been
entered.
If a power failure occurs, it is recommended to check the receipt print content before the receipt
is handed to the customer.
10. JOURNAL AND RECEIPT PAPER-END DETECTOR
(1)
This detects when either the journal or receipt paper is running out. It is provided to prompt the
operator to replace the old paper roll with a new one.
(2)
When the paper roll is running out (or the paper has not been set properly), no key operation is
accepted and the AMOUNT portion of the display keeps flickering.
(3)
When a new paper roll is set, only the [RF] and [JF] keys are allowed to operate. Next, when
the [C] key is^ depressed, the display flickering will be cleared and normal key-in operations will
be accepted. When any printing has been suspended, it will continue printing.
(4)
If this detector senses a paper-end condition during printing, the printing stops after the current
line printing is completed.
(5)
If the [C] key is depressed in the paper-end condition, it is ignored. The [C] key depression will
clear the display flickering only after the new paper roll is set.
- 3 6 -