Toshiba TEC MA-1400-100 - Manual (Page 45)

EOl-11014
Fig. 7
Fig. 8
Fig. 9
Ftg. 10
Fig. 11
13.2 REMOVING THE RECEIPT
PAPER
1. Remove the Paper Cover.
2. Tear the paper end off the paper core, pull the paper
end out while depressing the Free Lever, (Fig. 7)
3. Remove the paper core.
13.3 INSTALLING THE JOURNAL
PAPER
1.
2 .
3.
4.
5.
6
.
7.
8.
Turn the Mode Lock to the “REG’
power on. position with the
Remove the Paper Cover by pulling it upward, and
remove the Journal Winding Reel. (Fig. 1)
Follow Steps 3 and 4 of INSTALLING THE RECEIPT
PAPER procedure on the previous page.
Place the paper roll in the inner roll holder of the two
holders. (Fig. 8)
Insert the paper end into the Journal Inlet, feed the
paper in while pressing down the Free Lever (or feed
the paper in while pressing the [JF] key). (Fig. 9)
When a sufficient amount of paper comes out, wind
the paper around the Journal Winding Reel two or
three times, and set the Journal Winding Reel into the
Reel Holder. (Fig. 10)
Attach the Paper Cover.
Press the [C] key before starting operation.
13.4 REMOVING THE JOURNAL
PAPER
1. Remove the Receipt Cover.
2. Press the [JF] key to wind up enough of the journal
paper, and then tear off the paper, holding the Journal
Winding Reel.
3. The wound-up portion of the paper can easily be
removed from the Reel by pulling it sideways.
(Fig. 11)
4. If enough paper remains on the roll, follow Steps 6
through 8 above: if the paper is running out, follow
Steps 1 through 8 above.
NOTE: The [JFJ or [RF} keys function only when both
journal and receipt rolls have been placed in
their respective holders.
-39 -