Transmitter selcall id – Uniden UH-057 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4. Press the (0) Key to complete the programming.

Two beeps will be heard and the unit returns to its

previous status prior to accessing Programming Mode.

If you decided to use the 6 Tone Format, simply enter the

sixth digit when programming before pressing the©) Key.

To remove the Receiver SELCALL ID from Memory:

1. Follow step 1 and 2 of Receiver SELCALL ID program

ming.

2. Press the ©) Key.

Programming ends and no ID will be stored in the
memory. Whenever the Key is pressed, error tone

will be heard.

Note:

If you made an error in entering the ID, you must

abort the SELCALL programming and start over
again. To abort, press any key or switch not related
to SELCALL PROGRAMMING (e.g., PTTSwitch, UP
Key, HI/LOW Selector Switch... etc.)

Transmitter SELCALL ID

This ID is the Identification Code of the radio you want to

call. To program, do the following procedure.

Two beeps will be heard and the LCD displays:

2. Press the Key. The CAL indicator appears on the

LCD Display, and flashing.

UH-057

Page 28