Uniden UH-057 - Manual (Page 14)

(0>
©
ENTER Key; Press to enter the selected
Channel;
Press to store the RX/TX Code, Lead-In
Tone, Lead-In delay, and Tone Period
Setting when programming
Press and hold for 1.5 sec to enter special
programming modes.
Assigned as "E" tone when programming
Lead-In Tone ONLY.
TONE CALL Key; Press and hold for about
1.5 sec to transmit the transmitter ID (e.g,,
calling other radio by transmitting its
SELCALL ID)
Assigned as "A" tone when programming
RXID, T X I D o f Lead-In Tone.
TONE SQUELCH Key; Press and hold for
about 1,5 sec to put the receiver on “Quite"
Mode,
Assigned as “B" Tone when programming
RX ID, T X I D , o r Lead-In Tone.
PRIORITY Key; Press this key to store or
remove the selected Priority channel to/
from the memory buffer.
Assigned as "C"tone when programming
RX I D , T X ID, or Lead-In Tone.
Note: When shipped from the factory, no SELCALL codes
are stored in the memory. Error tone will be heard
everytime
GD or Key is pressed. To program,
please see page 27.
See page 34 for Numeric Keypad SELCALL Tone
Assignment.
UH-057 Page 12