Kenwood TH-415A - Manual (Page 9)

^ DOUBLE ROLE KEYS
PRIORITY BEEP STEP
h 1 1 2 1 1 3 1 |F 1
BAND MEMORY PROGRAM Tx STOP
h 1 1 5 1 1 6 1 I
SEEK TIME CARRIER KEY LOCK
h 1 |8 J 1 9 1 1 ENTER 1
FAST FAST
h 1 |o 1 U 1
( SCAN 1
___^___
These 13 keys except the |' f ~ | ,|
scan
L and 10 | keys,
have two functions.
The 1
St function is printed on the key.
The 2nd function is printed above the key.
All these 2nd functions are active for approx. 5 seconds
after pressing the I ^ I key.
• Numeric kevs:i~1 1^/|9 L 10 I
These keys are used to select the desired operating fre­
quency and/or memory channel number.
Memory channel 1, 8, and 9 also serve additional functions
as discribed below.
M. channel 1 is used to store the Priority Alert channel in­
formation.
M. channel 8 is used to store the lower, and M. channel 9
the upper limit frequency for the programmable band scan.
• UP/DOWN keys: [KJ , CZZI
These keys are used to increase or decrease the operating
frequency, offset frequency, tone frequency, or the power
saver circuit rate.
• F: Function exchange key
The I P I key is used to activate the 2nd function.
The F indicator is displayed for approx. 5 seconds after
pressing the I
F | key.
CAUTION :----------------------------------------------------------------------------------------
You must press the 2nd function while the F indicator is lit, or the
radio will perform the function printed on the key, rather than the
function printed above it.
• M: Memory key
The I M I key is used to select the desired memory chan­
nel.
The operation is similar to that of the I ^ I key, in that, the
M indicator will illuminate for 5 seconds in the LCD display.
CAUTION:-----------------------------------------------------------------------------------------
The memory channel must be selected within 5 seconds of press­
ing the
I M I key. * •
• ENTER key
The I ENTER I key is used to enter a frequency selected by
the numeric keys.
• SCAN key
The I SCAN] key is used to start or stop the scan function.
• PRIORITY CHANNEL CHECK key: [ED then 1/PRIO
These keys are used to monitor whether the priority chan­
nel (CH 1) is busy or not. When this function is activated,
the radio will switch to CH 1 approximately once every 10
seconds.
To cancel this function, press these keys again.