Programmable band scan key: eh, Carrier operated scan key: eh, Tx. stop key: ed then m/tx. stop – Kenwood TH-415A User Manual
Page 10: Key lock key: e3 then enter/key lock, Fast ed key: ed then t/fast, Fast i a i key: i i then a/fast, Operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• BEEP key: EH then 2/BEEP
Each time these keys are pressed, the audio annunciator
will be turned ON or OFF alternately.
• (FREQUENCY) STEP key:
[ED
then 3/STEP
Each time these keys are pressed, the frequency scanning
step size will be increased 5 kHz.
Several different scan function keys and scan stop keys are
provided.
• BAND SCAN key: I
^
I then 4/BAND
• MEMORY SCAN key:
TD
then 5/MEMORY
• PROGRAMMABLE BAND SCAN key: EH
then 6/PROGRAM
• SEEK OPERATED SCAN key: EH then 7/SEEK
• TIME OPERATED SCAN key: ED then 8/TIME
• CARRIER OPERATED SCAN key: EH
then 9/CARRIER
For additional information on this function refer to page 14.
• TX. STOP key: ED then M/TX. STOP
Pressing these keys will prevent accidental transmission.
To cancell this function, press these keys again.
• KEY LOCK key: E3 then ENTER/KEY LOCK
Depress these keys and the frequency and other settings
will remain unchanged by keyboard operation except the
LAMP key.
To cancel this function, press these keys again.
• FAST ED key: ED then T/FAST
• FAST I A I key: I I then A/FAST
10
OPERATION
■ RECEIVE
After power and antenna connections have been com
pleted, set the switches as follows:
1. Turn the VOL control clockwise to turn on power. The
frequency on the LCD display will show the transceiver
is operating.
2.
As the VOL control is turned clockwise, either
background noise or a QSO will be heard.
3. To eliminate the no-signal noise turn the SQL control
clockwise.
4. Enter the desired frequency.
■ TRANSMIT
Precaution: Check the intended transmit frequency before
operating to prevent interference with other
stations. If you are using T. SO (Tone
Squelch) press the MONITOR key to allow the
Squelch to open.
1. Simply depress the PTT switch and the I
ON
air
]
in
dicator will light.
2. Speak into the microphone. Recommended distance to
the microphone is approximately 2 inches (5 cm).
CAUTION:----------------------------------------------------------------------
Long transmission or extended operation in the 5 watt
mode might cause the rear of this transceiver to get warm.
Do not place the transceiver where the heat sink (rear
panel) might come in contact with plastic or vinyl surfaces.