Kenwood MS-A5 - Manual (Page 18)

18 i
When playing CDs, you сап program any desired tracks to
play in any desired order. This mode is called program
mode. To do this, you must be in programmed play mode.
Preparations
CD Lift the lid of the CD compartment,
(a) Insert the CD.
^[P16j (D Close the lid.
(4) If the CD is currently playing, press
the "B"key to stop it.
Tracks (Remote Control Unit Only)
Press the P.MODE key to enter program mode.
■rf-" DD:DD
—t
- Program mode
The number will change each time one of the keys is
pressed. ,
Display
rt:
Track no, Program number
(blinking)
D 5 P - 0 /
Stops blinking
If the P.ENTER key is pressed and held down for more than
2 seconds, the total playing time of the programmed track
will be displayed.
* Repeat steps H and M to program any other desired tracks. You may program up to 20 tracks.
• If you attempt to program any more tracks, the word FULL will appear on the display.
^lavina the programmed tracks
[T] To play the programmed tracks.
{■
—
^ Main Unit
>-/11
Remote
Control Unit T*
To stop programmed play.
Main Unit ^
■
Remote
1 Control Unit 0
^ 0 3 П П - - П f
The tracks will be played in the programmed order.
If the or key is pressed while the pro­
grammed tracks are being played, the unit will move to the
next programmed track in that direction.
CAUTION; Pressing the key again while the CD is
stopped will erase the current program.