Kenwood DP-M4010 - Manual (Page 6)

Before operation
Removal of packing materials (protec­
tive material) for transportation
Packing material
The packing material shown in the diagram has been
placed in the unit to protect it during tarnsprotation.
Remove the packing material before using. Do not throw
it away but keep for later use.'
When this unit is being transported, be certain to remove
the magazine from the unit and insert the original packing
material again.
Beware of condensation
Water vapor in the air may condense on cold parts, forming
"dew" on its surface.
For example, when a bottle is taken out of the refrigerator
and brought into a warm room, droplets of water will form
on the bottle surface. This phenomenon is called "conden­
sation". If this occurs inside the unit the player may operate
incorrectly or may not function at ail.
This is not a malfunction, however, the player should be
left until it is dry, (Turn the power of this unit ON and leave
the playerfor a while. After several hours, even in the worst
case, the player will stabilize and correct playback will be
possible.) Be especially careful in the following cases:
e When the unit Is suddenly brought from a cold place to
a warm place (causing rapid temperature change).
« When the temperature of the room is raised suddenly
using a heater, etc.
« When the unit is brought from a well-cooled (aircondi-
tioned) room to a damp and hot room.
® In conditions where the temperature difference be­
tween the surroundings and this unit might cause
condensation.