Kenwood DP-M4010 - Manual (Page 19)

In case of difficulty
What appears to be a malfunction may not always be serious. Firstly, check the following items before consulting
the service personnel.
Symptom Cause Remedy
No power is applied with the POWER
switch ON.
1 , Power plug is loosely connected.
2. With the power plug connected to the
linking power socket of an amplifier, the
power of the amplifier is turned off.
1, Insert the power plug firmly to the AC
outlet,
2. Turn the amplifier's power ON.
Disc is loaded, player does not play.
(DISC indicator turns off.)
1. Disc is loaded upside down,
2. Disc is dirty.
3. Disc is cracked.
4. Condensation occured on the optical
lens unit.
1. Load the disc again with its label side up.
2. Wipe off the dust on the surface of the disc
referring to "Cleaning of compact disc."
3. Replace the disc with a new one.
4. Leave the player for about 1 hour so that
the condensation is removed.
No sound. 1 . Disc is not loaded in the magazine.
2. Play mode is not entered, (The play/
pause indicator is not lit.)
3. Disc is too dirty.
4. Disc is cracked.
5. The connection cords are inserted
loosely.
1 . Load a disc and press the PLAY/PAUSE key
■
2. Press the PLAY/PAUSE key 1^/111 .
3. Wipe off the dust on the disc surface
referring to "Cleaning of compact disc".
4. Replace the disc with a new one,
5. Connect all connection cords firmly.
Music is interrupted. (Sound is skipped.) 1 . Disc is too dirty.
2. Disc is cracked.
3. Oscillation is applied to this unit.
1. Wipe off the dust on the disc surface
referring to "Cleaning of compact disc".
2. Replace the disc with a new one.
3. Try selecting a place where no strong
vibration occur by changing the installation
place, etc.
Play starts when POWER is turned ON. If the disc is loaded, this player will play from
the beginning of the first tune when the
power is turned ON,
If automatic play is not required, remove the
magazine from the player before turning the
power OFF.