Procedure, Installation of anti-tip bracket, Appiy foam tape – Bosch HDI7282U User Manual
Page 9: Instaii backwali trim (optionai), Connect eiectric
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Procedure
Installation of anti-tip bracket
1. Adjust height of range and level by rotating the ad
justable leg supports on the bottom of the range,
using l-%" (32 mm) wrench.
2. Locate bracket position as shown below.
3. Secure bracket with 2 screws to the floor or to
the wall. Depending on floor or wall material use
wood or anchorless concrete screws (included).
Concrete screws require a 3/16” masonry bit.
Screws should provide firm attachment into solid
wood or flooring. Do not attempt to anchor into
drywall.
Appiy Foam Tape
Apply foam tape to underside of cooktop trim in one
continuous piece.
Instaii Backwali Trim (Optionai)
Note: This step is only required if the countertop
does not connect behind the range (i.e.; when
replacing a free-standing range). If backwali trim
and attachment screws are required, they may
be ordered from the service center by calling
800-944-2904 at no charge for up to one year
after purchase date of your Slide-In Range.
When ordering, refer to Service
Backwali Trim Kit part no. 652010.
Install 2 screws through holes in trim and in range
backwali.
Install Backwali Trim Strip
Connect Eiectric
There are two possible electrical connections:
1. Four wire range cord
2. Three wire range cord
The four wire range cord connection is the recom
mended method, but where local codes permit,
three wire connections are also acceptable.
Note: In Canada, the range is shipped from the fac
tory with the range cord already installed.
For installations other than those in Canada, connect
the range cord at the terminal block (See next page
for detailed instructions). Access the terminal block
by removing the cover in the lower right hand corner
of the range back panel.