Bosch L0609466 - Manual (Page 9)

Gas Requirements
Installation
A Caution:
Make certain that gas shutoff valve and all burner controls are in the
OFF position before beginning.
Shut off main gas supply valve before disconnecting the old range and leave it off
until the new hook-up has been completed. Don’t forget to relight the pilot on
other gas appliances when you turn the gas back on.
The gas supply line and electrical outlet must be located in the shaded space as
shown in See Figure 4: Gas Supply Line and Electrical Outlet Placement.
Figure 4: Gas Supply Line and Electrical Outlet Placement
If not already present, install gas shut off valve in an easily accessible location.
Make sure all users know where and how to shut off the gas supply to the range.
Note:
The installer should inform the consumer of the location of the gas
shutoff valve.
Important note for LP users
The range is shipped from the factory for use with natural gas. For use with pro­
pane (LP) gas, your range must first be converted using the LP conversion kit.
Cabinet Requirements This unit is designed for installation near adjacent walls and projecting surfaces
constructed of combustible materials. Prepare the countertop and cabinets as
shown in See Figure 5: Cutout Requirements - Typical Installation.
English 7