beautypg.com

Caution – Kenmore 415.161108 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Main burner Ignitor Lighting

▲ Do not lean over grill while lighting.

1. Open lid during lighting.

2. Turn ON valve from source or tank.

3. Push and turn Ignition Burner control knob to ^ HI and

immediately press and hold Electronic Ignition button.

4. If ignition does NOT occur in 5 seconds, turn Left Burner

control knob OFF, wait 5 minutes for gas to clear and repeat
the lighting procedure.

5. To Light Other Burners turn control knob to Hi.

if ignitor does not work, follow match lighting instructions.

After Lighting: Turn knobs to HI position for 15 minutes to pre­

heat grill. Then turn knob to desired setting for cooking.

A

CAUTION

A

If burner

minutes
minute V

the valve

and cou

does not light, turn knobs to OFF, wait 5

and try again. Always close valve during

railing period. If the burner does not ignil

open, gas will continue to flow out of th(

d accidentally ignite with risk of injury.

the 5

e with

Î burner

Match-Lighting

A Do not lean over grill while lighting.

1. Open lid during lighting.

2. Place match into match holder (hanging from side of cart).

3. Push in and turn left knob to Hi position. Be sure burner

lights and stays lit.

4. Light right burner by pushing knob in and turning to^ HI

position.

Sideburner Ignitor Lighting

A Do not lean over grill while lighting.

1. Open lid or cover for Side Burner during lighting.

2. Turn

ON

valve from source or tank.

3. Push and turn Side Burner control knob to;^ HI and

immediately press and hold Electronic Ignition button.

4. If ignition does

NOT

occur in 5 seconds, turn Side Burner

control knob OFF, wait 5 minutes for gas to clear, and

repeat the lighting instructions.
If ignitor does not work, follow match lighting instructions.

After Lighting: Turn knobs to HI position for warm-up.

Sideburner Match Lighting

1. Open top cover. Turn on gas at LP tank.

2. Hold lit match to any port on the burner. Push in and turn

sideburner knob to ^ HIGH. Be sure burner lights and
stays lit.

Before Your First Cookout

• Light burners, check to make sure they are lit, close the lid and

warm up grill on HIGH for 15 minutes. This curing of paint and

parts will produce an odor only on first lighting.

Burner Fiame Check

• Light burner, rotate knobs from HIGH to LOW. You should see

a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.

Hose Check

• Before each use, check to see if hoses are cut, worn or kinked.

Replace damaged hoses before using grill. Use only

valve/hose/regulator specified In the Parts List.

Normal
Hose

Kinked
Hose

8.464810408