Burner, firebox and control knobs – Kenmore 415.161108 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Burner, Firebox and Control Knobs
; i Place burner assembly Into firebox (A). Fasten the burner assembly to the firebox using 5mm fiber washers and #10-24 x 1/2”
machine screws.
;.. Place firebox onto upper firebox supports with burner tubes below heat shield. Make sure burner tubes are correctly engaged . If
burner is not leveled from left to right, adjust the two screws attaching valve stems to control panel. Attach ignitor wire to ignitor (B).
; Attach firebox with #10-24x1/2" screws, 5mm fiber washers and #10-24 flange nuts (C).
Push control knobs onto valve stems (C).
Bunker Asserb'y
.
. »X
.
y'-KIlS'tfcl/'...
S'-::
%aa:*ii'
• •
\
27
34
13
#10-24X1/2” Screw 5mm Fiber Washer
#10-24 Flange Nut
Qty
. 6
Qty
. 6
Qty.4
Control Knob
I....
18*464810408