Pioneer VSX-D710S - Manual (Page 38)

Controlling the Rest of Your System
Learning Mode: Programming
Signals from other Remote
Controls
If preset codes are not available for your component(s),
or the available preset codes do not operate correctly,
you can use this function to program in signals from the
remote control(s) of your other component(s) This
operation can also be used after recalling a preset code
to program additional operations not covered in the
preset codes
38
En
Press SETUP and hold for three seconds
The LED on the remote control will light for two
seconds
To cancel the Learning mode at any time
Press SETUP
The remote control will also return to the previous
mode after thirty seconds of inactivity
VSX-D850S only: Use the <1 > buttons to
select the Learning mode
The Learning mode is indicated by the Learning icon
(LEARN) in the remote’s LCD display
Press the MULTI CONTROL button for the
component you want to control
VSX-D710S/D810S: Press and hold the
RECEIVER C!) button for two seconds to start
the Learning mode
The LED lights steadily
To cancel LEARNING setup mode
Press SETUP for one second
If no commands are entered within thirty seconds the
remote will revert to its previous mode
Point the two remote controls towards each
other Press the button to be learned on this
receiver’s remote control (for example the ►
[play] button)
c
1 - 2 inches
Point the remote controls directly at each other, about
1-2 inches apart, and press the button on the remote
control for the operation you want to program The
LED flashes rapidly For VSX-D850S, the LEARN icon
blinking
6 Press the corresponding button on the other
remote control to be taught to this receiver’s
remote control (in the above example the ►
[play] button)
Point the remote controls toward each other
Press the button on the other remote control
corresponding to the operation you wish to program
The LED on this receiver’s remote will go out and
then resume a steady light if the operation is learned
(Eor VSX-D850S model the LEARN icon will light
steadily and the LCD display tvill show “OK” if the
operation has been learned) If the operation hasn’t
been learned for some reason the LED will blink for
three seconds and then light steadily (Eor "VSK-
D850S model the LCD will display “error” if the
operation hasn’t been learned )
If this happens press the teaching key repeatedly,
varying the distances between the remotes, until you
see the LED on this unit’s remote light steadily,
without blinking first
To program additional operations for the current
component
Repeat steps 5 and 6
To program operations for another component
Repeat steps 2 through 6 (VSX-D850S)
Repeat steps 3 through 6 (VSX-D710S/D810S)
7 Press and hold SETUP for one second to exit
the LEARNING setup mode
After thirty seconds of inactivity the remote control
will automatically leave the LEARNING mode and
revert to its previous mode
MEMO:
• Some commands from other remote controls cannot
be learned, but in most cases the remotes just need to
be moved closer together or farther apart
• Certain buttons represent modes that cannot be
learned from other remote controls These include
RCV, CH SELECT, CH LEVEL, FUNCTION
LOUDNESS, FL DIMMER, and MUTING
• TV CONTROL buttons (TV O, VOL +/-, and TV
FUNC ) can only be learned in TV & TVC mode