Pioneer VSX-D710S - Manual (Page 21)

Preparations
Optical digital input 4 setting (VSX-
D850S only)
Here you tell the receiver -what component you have
hooked up to the optical input jack 4
Press A or V to select the optical digital
input 2 (DVD, TV, CD, CD-R, VCR, or OFF)
After you assign a component to this digital jack
whenever you select that component, for example a
CD player, the receiver will automatically change to
the digital input setting You can see this in the
DIGITAL/ANALOG indicator on the front of the
MEMO:
♦ The initial setting is “VCR”
• The digital out signal corresponds to the selected
input function (for example, DVD)
Setting the Volume Level of
Each Channel (adjusting the
speaker volume balance)
Use to set the relative volume of each channel
3 Press TEST TONE to output the test tone
The test tone is output in the following order
VSX-D710S
FL —► CT —► FR
sw SL SR
Z]
VSX-D810S/D850S
FL —► CT — FR
SW SL
-► SR —,
SB
• Test tone is only output in Dolby/DTS modes The
test tone sequence corresponds to the speaker setting
mode
4 Adjust speaker levels so that you hear the
test tone at the same volume from each
speaker when seated in the main listening
position
• If a speaker is deselected in the speaker setting mode
(see p 17) then no test tone will be output for that
speaker
• The channel level range is ± 10 dB
• Levels can be set for each surround mode
5 Press TEST TONE to turn off the test tone
MEMO:
• Since the SUBWOOFER transmits an ultra-low
frequency its sound may seem quieter than it actually
is
• The speaker volume can be adjusted without
outputting the test tone by pressing CH LEVEL or
CH SELECT button
• Initial setting is 0 dB
• You can set each sound mode individually and these
settings are completely independent of each other
The sound modes you can set include DSP stereo,
DVD 7 1 Ch and DQ/DTS, as explained in steps
above However, you can only use the test tone
feature when setting [I1A)TS
1 Press DD/DTS
2 Press MASTER VOLUME + or - to adjust the
volume to an appropriate level
21
En