Memo, Playing other sources, Midnight listening mode – Pioneer VSX-D710S User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Sound Modes

DVD 5.1 ch./7.1 ch (5.1 ch for VSX-
D710S) input playback

If you want you can connect a component with 7 1
channel (5 1 channel for VSX-D710S) analog output to

enjoy surround sound playback In this case the
surround sound will be externally decoded and then fed
into the receiver

DVD/LD
MULTICONTROL-

RCV-

I I

51/71

® © (

€> ©_© ©

€) © © ©

® ® cp>

CD cD””D

CD ^

CutSS DTVtfMW P1VWHU I

1 Press RCV

This sets the remote to select the sound mode

(You can skip this step when using the controls on

the receiver )

2 Press MIDNIGHT

Each press switches MIDNIGHT listening mode on or
off

MEMO;

• The effect automatically adjusts according to the

volume level

Playing other Sources

To switch on DVD 7 1 ch (5 1 ch for VSX-

D710S) mode press the DVD/LD MULTI

CONTROL button on the remote, then RCV,

then 5.1/7.1 button

VSX-D710S only: On the main unit press the

DVD 5 1CH button to switch on 5 1 ch mode

Press the 5 1/7.1 button on the remote to go

back to the DVD/LD mode If you’re using

the main unit, choose any other function

with the MULTI JOG

MEMO:

• When 5 1 ch/7 1 ch input is selected, Dolby mode,

DSP mode, SIGNAL SELECT, ATT, DIRECT, TONE,
MIDNIGHT mode, LOUDNESS and speakers B
cannot be operated

• When 5 1 ch/7 1 ch input is selected, only the

volume level and channel levels can be set

MIDNIGHT Listening Mode

When listening at low volume, surround effects tend to
become less than satisfactory Turn the MIDNIGHT

listening mode on to enjoy the effects of quality
surround sound even at low volumes This mode allows

you to hear effective surround sound of movies at low
volume levels

T---------

5n_\_

@ © Q

© © © ©

_ Muin coKimn

CD CD™D

class

OTVOWPff CPTVUENU I

® ® ® ® I

(Q 0 0 ©

0^0 0 0

(D CD CD

j ® CD

CD CD”

® CD ®

® ®

WW>

tma/oir Btvjjpu I

CD O (3-

Turn on the power of the playback

component

Turn on the power of the receiver

Be sure that the standby indicator turns off on the

front panel

Press MULTI CONTROL buttons or the

FUNCTION button to select the source you

want to playback

If the DIRECT FUNCTION is OFF you have to use

the FUNCTION button to select the source (see
p39)

If necessary, press SIGNAL SELECT to select

the input signal corresponding to the source
component (see p 29)

Start playback of the component you

selected in step 1