beautypg.com

Remember — do not allow spills, food, cleaning, Dual burner head assembly (some models only), Step 2 – Kenmore GAS A GE-SLIDE IN MODEL 790.3104 User Manual

Page 9: Before setting surface controls

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates for Regular Burners

It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates

are installed correctly and at the correct locations.

1. Remove all packing tape from cooktop area. Remove all

Burner Caps and Burner Heads.
Discard all packing material located under Burner Heads (if

applicable).
To replace the Burner Heads & Caps, match the letters

located under center of Burner Caps with the letters located
inside Burner Heads (Figure 1).
Match Burner Skirts with Burner Heads and Burner Caps
(see Figure 1). Replace the Burner Heads and Caps on

cooktop (see Figure 2). Carefully align the Electrodes into
slot or hole of each Burner Head (Figure 3). Note: The

Burner Heads should sit flat on Cooktop Burner Skirts.
Place the removable oven vent cover over the fixed oven

vent cover.

Unpack Burner Grates and position on the cooktop.

Before Setting Surface Controls

2

.

3.

4.

5.

6

.

Figure 3

“ Electrodes must

align into slot or hole for each

Burner Head

REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING

AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner
Caps and Burner Heads in place whenever the surface burners are in use.

ir;i

f..

Dual Burner Head Assembly (some models only)

Make sure that the Burner Head, Burner Caps and Burner Skirt are
installed properly and at the correct locations.

1. Follow the Installation Instructions before installing and using your

new range.

2. Remove all packing tape from cooktop and the dual burner.
3. Discard all packing material located under all Burners (if applicable).
4. To install Burner Head, Caps & Skirt, refer to figure 1 and follow the

following steps:

Step 1: Align Burner Head Pin A on Burner Base Hole.
Step 2: Place Burner Skirt around Head and Base.
Step 3: Align the Burner Outer Cap Hole into Burner Head Pin B.
Step 4: Place Inner Burner Cap centered on Burner Base.

5. Put back the grates on the cooktop.

REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING

AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keep the Burner Caps and

Burner Heads in place whenever the surface burners are in use.

Burner
Inner Cap

Burner —
Outer Cap

Burner Outer
Cap Hole

Burner
Skirt

Step 4

Step 3

Step 2