Operating the warmer drawer, Warmer drawer food temperature settings – Kenmore GAS A GE-SLIDE IN MODEL 790.3104 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Warmer Drawer Controls (SOIVIE iViODELS ONLY)
Arranging Warmer (Warm & Ready'^“) Drawer Rack Positions
The rack can be used in 2 ways:
•
In the upright position to allow low profile food items to be placed both under and on top of the rack (for example,
rolls or biscuits on top of the rack and a casserole dish underneath).
•
In the downward position to allow you to place light weight food items and empty dishware (for example, rolls or
pastries and dinner plates) on the rack.
Set the Warmer Drawer Rack in either position as shown below (Figure 1).
Warmer Drawer Rack in
downward position
Operating the Warmer Drawer
The purpose of the Warmer Drawer is to keep hot cooked foods at serving temperature. Always start with hot food. It is
not recommended to heat cold food in the Warmer Drawer. All food placed in the Warmer Drawer should be covered
with a lid or aluminum foil to maintain quality. Do not use plastic wrap to cover food. Plastic may melt onto the
drawer and be very difficult to clean. Use only utensils and cookware recommended for oven use in the Warmer
Drawer.
ik CAUTION
I Always use potholders or oven mitts when removing food from the Warmer Drawer as cookware and
plates will be hot and you can be burned.
Warmer Drawer Food Temperature Settings
Use the recommended settings in the Warmer Drawer settings table. If
a particular food is not listed, start with the MED setting. If more
crispness is desired, remove the lid or aluminum foil from the food.
Most foods can be kept at serving temperatures on the MED setting.
When a combination of foods are to be kept warm (for instance, meat
with 2 vegetables and rolls), use the HI setting. To avoid heat loss, do
not open the Warmer Drawer repeatedly while in use.
Warmer (Warm & Ready'^“) Drawer & Bread Proofing
Indicator Lights
The control and indicator lights for the Warmer Drawer and Bread
Proofing features are located on the control panel. The indicator lights
will turn ON when the control is set, and remain ON until the controls
are turned OFF.
Note: The warmer Drawer will not operate during the Self-Clean
cycle.
Warmer Drawer Settings Table
Food Item
Setting
Bacon
HI
Hamburger Patties
HI
Poultry
HI
Pork Chops
HI
Fried Foods
HI
Pizza
HI
Gravies
MED
Casseroles
MED
Eggs
MED
Roasts (Beef, Pork, Lamb)
MED
Vegetables
MED
Biscuits
MED
Rolls, hard
MED
Pastries
MED
Rolls (soft)
LO
Empty Dinner Plates
LO
Figure 2
36