Threading the double needle, Thread selection, Muble needle – Kenmore 15/I649 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
mUBLE NEEDLE
24
Raise the needle bar to its highest position and loosen needle
ciamp screw Hoid double needle assembly with flat side away
from you. Slip the needle as far as it will go into needle clamp,
and tighten the screw.
SETTING THE DOUBLE NEEDLE
THREADING THE DOUBLE NEEDLE
Piace a Spool of thread on each spool pin Draw both threads
through upper thread guides Pass a thread between each set
of tension discs of the thread tension assembly Continue thread
ing as you would for single needle sewing except where double
thread guides are provided Draw one thread through each side
of the double thread guides and through each needle from front
to back. Pull several inches of thread through Thread bobbin
and pick up bobbin thread as for single needle sewing.
THREAD SELECTION
Use only mercerized sewing thread size 50 or finer. The same
size thread is recommended for both upper and lower threading.