Kenmore 15/I649 - Manual (Page 19)

SEWING ON BUTTONS Us® disc # 1A
Align two holes of button with slot of prssser foot and
lower fool to hold securely. Drop feed dog Turn hand
wheel by hand urtti! needle point is just above button. Adjust
stitch width so that needle will align with a hole of button
Turn hand wheel again by hand so that needle goes into
second hole, readjust stitch width if necessary. Stitch a
number of times, turning hand wheel manually Finish
sewing with an extra 2 inches of thread, draw thread to
reverse side and tie securely ^ , •
If using a 4 hole button repeat the dbove procedure
NOTE: To make a small thread shank when sewing on a
flat button, place a straight pin or needle betweert the holes
of the button.
BLIND STITCHING ‘ ,
Disc #1B
ititS leng\h 3 depending on type of material)
1 Prepare the hem with a turned and edgestitched finish,
or
2 Apply seam tape along the raw edge with either straight
or zigzag stitching,
3 Turn hem and baste about H inch from the edge of the
seam tape using longest stitch on the sewirtg machine.
4 Fold garment back along basting line and stitch along
garment fold using disc #1B
5 Remove basting and press hem. The basting step may
be alimineted in s straight hem
19