beautypg.com

Changing the presser foot, Turning a corner, Fastening a seam – Kenmore 15/I649 User Manual

Page 15: Feed dog control

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CHANGING THE PRESSER FOOT

The various attachment feet Bvaiiabia for certain kinds of work are to be
fastened to the presser bar.

To attach the foot, raise the prasser bar to its highest position by raising
the presser foot iever. Loosen the presser foot thumb screw, choose the
proper foot, insert from the front Tighten the screw using the large screw
driver and make sure that the foot is secyre-

TURNING A CORNER

stop sewing machine with needle in fabric. Raise presser foot
Lower presser foot and continue stitching.

Turn fabric

FASTENING A SEAM

Be sure both threads are drawn back under the presser foot Lower needle

into fabric about inch from beginning of seam Push stitch length

control lever up for reverse stitching Stitch in reverse until needle reaches
beginning of seam

,

Move stitch length controi lever down for forward stitching and complete
seam. When you reach the end, raise the stitch length control lever and
sew back over Inch of completed seam

''iii

FEED DOG CONTROL

The feed dog control knob is situated on the right front of

machine bedplate. When knob is turned to the other side
of "U" mark, feed dog drops and does not puli material.

This allows the operator freedom of movement of material,

as for darning, For regular sewing, turn knob to the "U"
mark [Feed dog up)

Model 150

15