Kenmore 415.165059 - Manual (Page 8)

Main burner Ignitor Lighting
A
Do not lean over grill while lighting.
1. Open lid during lighting.
2. Turn ON valve from source or tank.
3.
Push and turn Ignition Burner control knob to ^ HI and
immediately press and hold Electronic Ignition button.
4.
If ignition does NOT occur in 5 seconds, turn Left Burner
control knob OFF, wait 5 minutes, and repeat the lighting
instructions.
5. To Light Main Burner, turn control knob to HI.
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for 15 minutes to pre­
heat grill. Then turn knob to desired setting for cooking.
t
CAUTION
If
burner
does not light, turn knobs to OFF, wait 5
minutes, and
try
again. Always close valve during the 5
minute waiting period. If the burner does not ignite with
the valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
Match-Lighting
A Do not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging from side of cart).
3. Push in and turn left knob to ^ HI position. Be sure burner
lights and stays lit.
4. Light right burner by pushing knob in and turning to^ HI
position.
Sideburner Ignitor Lighting
A Do not lean over grill while lighting.
1. Open lid or cover for Side Burner during lighting.
2. Turn
ON
valve from source or tank.
3. Push and turn Side Burner control knob to^ HI and
immediately press and hold Electronic Ignition button.
4. If ignition does NOT occur in 5 seconds, turn Side Burner
control knob OFF, wait 5 minutes, and repeat the lighting
instructions.
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for warm-up.
Sideburner Match Lighting
1. Turn OFF all burner control valves.
2. Open sideburner lid (if equipped).
Turn on gas at LP cylinder.
3.
Place lit match near burner.
4. Turn sideburner knob to
^ HI. Be sure burner
lights and stays lit.
Before Your First Cookout
•Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. This curing of paint and
parts will produce an odor only on first lighting.
Burner Flame Check
•Light burner, rotate knobs from HIGH to LOW. You should see
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. If only low flame is seen refer to
"Sudden drop or low flame" in the Troubleshooting Section.
Hose Check
•Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified in the Parts List.
Normal
Hose
Kinked
Hose
•Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.
•Do not use water on a grease fire. Personal injury may
result. If a grease fire develops, turn knobs and LP tank
off.
•Do not leave grill unattended while preheating or
burning off food residue on high. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product. Follow instructions on General
Grill Cleaning and Cleaning The Burner Assembly to
prevent grease fires.
8 • 464722309 • 464722509