Upper and lower front panel and top brace, Back brace to cart – Kenmore 415.165059 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Upper and lower Front Panel and Top brace
Lay front legs down on the floor. Fit upper front panel between legs. Attach with 2” hinge pins and hitch pins
Attach lower front panel with #10-24x2” machine screws and #10-24 flange nuts .
Attach top brace with #10-24x2” machine screws and #10-24 flange nuts .
#10-24
Flange Nut
Qty. 8
Hitch Pin
Qty. 2
Right leg
assembly
Left leg
assembly
10-24x2”
Machine Scre^
N
j’ Hitch Pin
Top brace
W ^
■
■■■
#10-24x2”
■
Machine Screw 2” Hinge Pin
Qty.8
Qty.2
—
Lower Front Panel
Hitch Pin
2”^inge Pin
'“'-^#10-24x2”
Machine Screw
Back Brace to Cart
n Remove previously attached screws and nuts securing the upper leg and side brace as noted below. Attach upper and lower back
braces with #10-24x1-1/4"
screws
and
#10-24 flange nuts.
#10-24x1-1/4”
Machine Screw
Qty.7
(One re-used)
\
#10-24
Flange Nut
Qty.7
(One re-used)
Back Brace
Note:
Remove previously installed
screw and nut from location
shown to attach upper back brace.
'#10-24x1-1/4”
Machine Screw
Back Brace
14
-464722309
-464722509