beautypg.com

Troubleshooting - electronic ignition – Kenmore 415.165059 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Troubleshooting - Electronic Ignition

Problem (Ignition) Possible Cause

Check Procedure

Prevention/Solution

SECTION 1

No sparks appear at

any electrodes when

control knob turned to

S-

; no noise can be

heard from spark

module.

•Battery not installed

properly.

•Dead battery.

•Check battery orientation.

•Has battery been used

previously?

•Install battery (make sure that “+” and

connectors are oriented correctly, with “+” end up

and end down.)

•Replace battery with new AA-size alkaline battery.

•Button assembly not

installed properly.

•Check to insure threads are

properly engaged. Button

should travel up and down

without binding.

•Unscrew button cap assembly and reinstall, making

sure threads are aligned and engaged fully.

•Faulty spark module.

•If no sparks are generated

with new battery and good

wire connections, module is

faulty.

•Replace spark module assembly.

SECTION II

No sparks appear at

any electrodes when

control knob turned to

^

; noise can be

heard from spark

module.

•Output lead

connections not

connected.

•Are output connections on

and tight?

•Remove and reconnect all output connections at

module and electrodes.

SECTION III

Sparks are present

but not at all

electrodes and/or not

at full strength

•Output lead

connections not

connected.

•Electrical arc between

output wires and grill

frame.

•Are output connections on

and tight?

•If possible, observe grill in

dark location. Operate

ignition system and look for

arcing between output wires

and grill frame.

•Remove and reconnect all output connections at

module and electrodes.

•If sparks are observed other than from burner(s),

wire insulation may be damaged. Replace wires.

•Weak battery.

•All sparks present but weak

or at slow rate.

•Replace battery with a new AA-size alkaline battery.

•Electrodes are wet.

•Has moisture accumulated

on electrode and/or in burner

ports?

•Use paper towel to remove moisture.

•Electrodes cracked or

broken; Sparks at

electrode crack.

•Inspect electrodes for

cracks.

•Replace cracked or broken electrodes.

464722309

464722509

27