Kenmore 415.165059 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Burner and Firebox and Control Knobs

Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24x1/2”

machine screws (A).

Inside firebox, insert heat diffuser supports with 5x15 fiber washers to firebox through sides of firebox, then secure with

#10-24 flange nuts on outside of firebox (A).

Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,

adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor ( B ).

Attach firebox with #10-24x2” machine screws, 5x15 fiber washers and #10-24 flange nuts ( C ).

Push control knobs onto valve stems ( C ).

^ Burner assembly

rebox

4...

Heat

diffuser

k support

Control Knob

Heat shield

for Tank

Valve ■

#10-24

Flange Nut

Qty.8

5x15

Fiber Washer

Qty.10

#10-24X1/2”

Machine Screw

Qty.6

Heat diffuser Support

Qty.4

Make sure the burner tubes are located

underneath Heat Shield

-464722309

-464722509