beautypg.com

Kenmore 116.22813 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TO REPLACE BELT

1. Sfide washers
and end caps onto
agitator assembly

2. Install r^ew

beit over motor

drive, then
over brush

sprocket,

NOTE: See
PARTS AND
FEATURES for
Belt Number

Motor
Drive

Agitator

3. Place agitator
assembly back into

Power-Mate®.

4. Reinstall
agitator
cover by lin­
ing up the
front tabs

and slots
and rotating ,
downward
until the
iatches
snap Into place.

Agitator Cover

5, Line up

front of

cover and
base. Rest
cover on
front edge of
Uabc do
shown.

Base

Top View

6, NOTE: On dirt
sensor models
be sure that the

board is upright
and the wires are
tucked back as
shown.

7. Rotate cover
back. Press cover
firmiy until side

and rear tabs snap
into piace.Turn

Power-Mate®
upside down and
replace two (2)

cover screws.

1, Remove Power-Mate® cover as shown in
BELT CHANGING AND AGOATOR CLEAN­

ING section.

2. Push in and turn
buib counterclock­
wise, then pui! out
to remove.

3. Push in and turn
bulb clockwise, to

replace. Bulb must
not be higher than

15Watts(130 Volts).

4. Reinstall Power-Mate® cover as shown in

BELT CHANGING AND AGITATOR CLEAN­
ING section

NOTE: See PARTS AND FEATURES for

Bulb Number

18

This manual is related to the following products: