Kenmore 116.22813 - Manual (Page 15)

CLEANING EXTERIOR AND ATTACHMENTS
1. Unpiug cord from wali outlet DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry
Wipe dry after cleaning,
3. To reduce static electricity and dust build­
up, wipe outer surface of cleaner and
attachments.
I T10 N
Do not use attachments if they
are wet. Attachments used in
dirty areas, such as under a
refrigerator, should not be used
on other surfaces until they are
washed. They couid leave marks.
//
MOTOR SAFETY FILTER CHANGING
Check motor safety filter occasionally and
change when dirty
WARNING
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock.
Remove the bag as outlined in the BAG
CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
This white filter must be replaced when
dirty. It should be replaced regularly
depending on use conditions. The filter
CANNOT be washed as it will lose Its
dust trapping ability.
NOTE: See PARTS AND FEATURES for
Motor Safety Filter Number
1. Lift the rubber
retainer and pull
out motor safety
fiiter as shown.
2. Replace the fil­
ter, rough side
out, facing the dust
bag, by sliding it
back into place
under the ribs in
the bag cavity
Tuck filter in so that
it fits completely
under the rubber
retainer.
3. Replace the bag as outlined in the BAG
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh­
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc, can clog
the bag and cause it to burst before
it Is full. Change bag more often
when vacuuming these materials.
15